Help THE NOUN plug-in Pause at height - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

После паузы в 3,8 мм, чтобы изменить катушки, уплотнение продолжается на слое выше 4,1 мм (слой пропускает). Придется вручную изменить на 3,8 мм. Эта ошибка продолжается уже давно. Правильно!!! WDI3_20х20х0,8х10.gcode

Cura 4.10.0 Pause at Height/Layer corrupts line width and layer

How can I raise a model above the print bed so more support is

Cura 4.10.0 Pause at Height/Layer corrupts line width and layer

Problem with raised letters - UltiMaker Cura - UltiMaker Community

How to Use Cura Pause at Height – A Quick Guide - 3D Printerly

How could I adjust the Helpers in cura ultimaker?? - Improve your

Tree Supports not generating for overhang · Issue #13033

Excluding support from a certain area or past a certain height

Issues with Pause at height - UltiMaker 3D printers - UltiMaker

Introduction of Cura: “Pause At Height” - 3D Printing Fox

Problems with cura not printing some of my model - UltiMaker Cura

4.0.0] Pause at Height plugin restarts too high · Issue #5924