Cura generated code on CR-10; heats only bed and not nozzle; doesn

Using Cura, I select my printer, CR-10 (1.1.6), the correct flavor, Merlin, verify that I have a temperature of 205 for the nozzle and 60 for the bed, and slice the file and save as gcode. When I attempt to print, the nozzle will heat correctly, but the temperature set point for the bed remains a

ultimaker cura - Filament lifts from the hot bed while printing - 3D Printing Stack Exchange

Creality CR-10 S5 3D Printer, 3Ding

Just won't hit those nozzle temp targets from cura to start the print. Lower the temp with print tune screen and it starts up in 30 seconds or so. Bought a new

creality ender 3 - Cura variables and initial G-code commands - 3D Printing Stack Exchange

【Large Format Build Volume】450*450*470mm build volume meets larger printing size needs. You can enjoy bigger models printing without worrying various

Official Creality CR-M4 3D Printer with Sprite Dual-Gear Direct Extruder 300°C Hotend 25-Point CR Touch Auto-Leveling Kit Dual-Y axis Linear Rails

Creality CR-6 SE, CR-6 MAX & CR-10 Smart Community, It's the waiting that gets to me

The Best Simplify 3D Settings for the Creality CR-10 With latest WORKING discounts SEP 2017

CR-10 V2 upgraded, Nozzle not heating : r/CR10

Creality CR-6 SE, CR-6 MAX & CR-10 Smart Community

Best Cura Settings & Profile for CR-10 Smart Pro – Tested!

Cr-10 Smart: Rookie asking how to reduce print time : r/CR10